Kampmann GmbH & Co. KG
PowerKon LT - Baugröße 2
Registration Code: 9QPY13
Metalle
Product description
A heat pump is essential for the contemporary heating of existing as well as new buildings. Low system temperatures are crucial for the efficiency of the heat pump. Under these conditions, PowerKon LT units provide for heating and cooling with maximum comfort. The fan coil can be used in existing and new residential and commercial buildings. Existing heaters in buildings can be replaced with PowerKon LT units with little installation work involved and thus produce sufficient heat output at low system temperatures. Also in new buildings, the PowerKon LT can heat up a room within a few minutes and therefore can meet the demand in rooms where a fast respond is required. Additionally, using wet cooling in summer can help to air-condition rooms.Instructions for use
The units are only intended to be used for heating and cooling air in frost-free and dry rooms. Within the room, the unit needs to be connected to the building's heating/cooling/ventilation system and to the building's waste water and power network. The operating limits and limits of use described in the installation instructions must be observed.Reference to the DGNB system
ENV1.1 Building life cycle assessment
ENV1.1 Building life cycle assessment
Photochemical ozone creation potential (POCP)
1) Production stage
5,27E-01
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
2) Use stage
1,13E-02
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
3) End of life stage
4,16E-02
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
4) Benefits and loads beyond the system boundries
-1,34E-01
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
Unit
kg NMVOC-Equivalent
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
Non-renewable primary energy demand (PEne)
1) Production stage
1,33E+03 MJ
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
2) Use stage
2,67E+01 MJ
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
3) End of life stage
2,67E+00 MJ
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
4) Benefits and loads beyond the system boundries
-3,74E+02 MJ
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
Renewable primary energy demand (PEe)
1) Production stage
2,41E+02 MJ
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
2) Use stage
3,03E+00 MJ
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
3) End of life stage
2,55E-01 MJ
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
4) Benefits and loads beyond the system boundries
-8,79E+01 MJ
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
General life cycle assessment data
Building material class
not relevant
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
Reference Unit
1 unit
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
If necessary, conversion of the reference unit
No conversion necessary
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
End of life cycle
End of life cycle is modelled according to JRC Report, Annex C V2.1.
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
Useful life
20 years
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
Global Warming Potential (GWP)
1) Production stage
9,28E+01
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
2) Use stage
1,63E+00
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
3) End of life stage
5,54E+00
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
4) Benefits and loads beyond the system boundries
-2,91E+01
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
Unit
kg CO2-Equivalent
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
Eutrophication potential (EP)
1) Production stage
9,32E-03
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
2) Use stage
2,43E-04
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
3) End of life stage
8,83E-04
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
4) Benefits and loads beyond the system boundries
-1,66E-03
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
Unit
kg P-Eq. [EP-freshwater]; kg N-Eq. [EP-marine]; mol N-Eq. [EP-terrestrial]
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
Acidification potential (AP)
1) Production stage
1,40E+00
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
2) Use stage
3,24E-02
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
3) End of life stage
1,97E-01
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
4) Benefits and loads beyond the system boundries
-2,25E-01
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
Unit
mol H+- Equivalent
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
Ozone Depletion Potential (ODP)
1) Production stage
2,30E-06
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
2) Use stage
4,78E-08
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
3) End of life stage
9,07E-08
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
4) Benefits and loads beyond the system boundries
-7,78E-07
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
Unit
kg CFC11-Equivalent
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
ENV2.2 Potable water demand and waste water volume
ENV2.2 Potable water demand and waste water volume
Installation-specific connected load
Flow rate (for sanitary fittings)
not relevant l/sec
- Source
- Manufacturer
- Quality
- [Unaudited manufacturer specification]
Average flushing volume (of the sanitary equipment)
not relevant l/flush
- Source
- Manufacturer
- Quality
- [Unaudited manufacturer specification]
ECO1.1 Life cycle costs
ECO1.1 Life cycle costs
Actual useful life
20 years
- Source
- EPD S-P-12774
- Quality
- [Externally audited specific manufacturer information]
PRO1.4 Ensuring sustainability aspects in tendering and contracting
PRO1.4 Ensuring sustainability aspects in tendering and contracting
Tender textes
Product-related tender texts available, reference to EPD and registration in the DGNB Navigator in the tender texts.
- Source
- Tender texts PowerKon LT
- Quality
- [Unaudited manufacturer specification]
PRO2.5 Preparation of sustainable use
PRO2.5 Preparation of sustainable use
Maintenance, inspection, operating and care instructions
Yes, included in assembly instructions.
- Source
- Assembly instructions PowerKon LT
- Quality
- [Unaudited manufacturer specification]
SOC1.2 Indoor air quality
SOC1.2 Indoor air quality
Indoor hygiene - volatile organic compounds VOCs
Formaldehyde concentration
- Source
- Manufacturer
- Quality
- [Unaudited manufacturer specification]
Other emission tests / labels
not relevant
- Source
- Manufacturer
- Quality
- [Unaudited manufacturer specification]
TVOC value
- Source
- Manufacturer
- Quality
- [Unaudited manufacturer specification]
Approval test according to AgBB scheme is available
not relevant
- Source
- Manufacturer
- Quality
- [Unaudited manufacturer specification]
SOC1.3 Acoustic comfort
SOC1.3 Acoustic comfort
Rated building sound insulation value R`w
not relevant dB
- Source
- Manufacturer
- Quality
- [Unaudited manufacturer specification]
SOC1.4 Visual comfort
SOC1.4 Visual comfort
Visual contact with the outside
Class of the sun/glare protection with regard to visual contact to the outside
not relevant
- Source
- Manufacturer
- Quality
- [Unaudited manufacturer specification]
Colour rendering
Color rendering index Ra of artificial lighting
not relevant
- Source
- Manufacturer
- Quality
- [Unaudited manufacturer specification]
TEC1.3 Quality of the building envelope
TEC1.3 Quality of the building envelope
Class of air permeability (joint permeability)
not relevant
- Source
- Manufacturer
- Quality
- [Unaudited manufacturer specification]
Heat transfer coefficient U
not relevant W/(m²K)
- Source
- Manufacturer
- Quality
- [Unaudited manufacturer specification]
Manufacturer note
Note on document download
All documents mentioned in this product profile (technical catalogue, environmental product declaration (EPD), assembly instructions) are available in their current version in the document download on the Kampmann GmbH & Co. KG website.
Note on LCA data
The LCA data given were calculated according to the specification of the EN 15804:2012+A2:2019/AC:2021 standard.Contact the manufacturer
Kampmann GmbH & Co. KG
Kampmann GmbH & Co. KG
Friedrich-Ebert-Straße 128-130 49811 Lingen (Ems)
Related products from this manufacturer
#MFAL2L
Venkon - Baugröße 63
Kampmann GmbH & Co. KG
In Komfortgebäuden aller Art mit hohem Heiz- und Kühlbedarf sowie hohem Raumnutzer-Anspruch kommen Fan Coils zum Einsatz. Der Fan Coil Venkon ist in vier Baugrößen erhältlich und kann als Grundgerät flexibel mit Verkleidungen kombiniert werden. Der E…
#V2A2ET
Katherm QE 1250 mm
Kampmann GmbH & Co. KG
Bodenkanalheizungen Katherm QE sind die ideale Lösung, wenn der Einsatz eines Konvektors mit Pumpenwarmwasser nicht möglich oder nicht vorgesehen ist. Sie zeichnen sich durch energiesparende und sehr leise laufende EC-Querstromventilatoren in Kombina…
#L60IFX
KaDeck zweiseitig ausblasend, feuchte Kühlung
Kampmann GmbH & Co. KG
In Büroräumen mit hohem Glasflächenanteil und Personenaufkommen entstehen Kühllasten, die ohne eine Klimaanlage nicht abgeführt werden können. Für diesen Einsatzbereich bietet der KaDeck eine flexible Raumklimatisierung für die Decke zum Kühlen und H…